Latex Zombie Mask Blank DIY- Made to Order
Please read entire listing before purchasing.
This is an unfinished raw latex pull of my zombie mask design. It will require some know-how to finish.
All edges are left intact from the mold. Eyeholes are uncut. Large airbubbles are patched, but the piece may have small surface imperfections that can be covered with paint or PAX (see close-up image for an example of air bubbles).
Latex pieces are cast using Reynolds Latex and are usually about 1/8 inch (3mm) thick. Pieces are cast upon ordering so if you would like a thinner piece, please note that in the comments.
Pieces will ship in a box with packing material stuffed in the inside of the mask. This should prevent any major deformations. However, you may need to heat up this piece with a hair dryer in order to get it to snap back to its proper shape after shipping.
Mask blanks ship 2-3 weeks after placing your order, as they are made after order is placed. If you need a piece more quickly please message me at micah@micahebbe.com and I may be able to get it out sooner!
While I try to answer all my messages I am unable to offer step-by-step instructions on how to finish this piece.
If you are looking for more information on how to finish latex masks, please check out the Stan Winston school tutorials!
Please read entire listing before purchasing.
This is an unfinished raw latex pull of my zombie mask design. It will require some know-how to finish.
All edges are left intact from the mold. Eyeholes are uncut. Large airbubbles are patched, but the piece may have small surface imperfections that can be covered with paint or PAX (see close-up image for an example of air bubbles).
Latex pieces are cast using Reynolds Latex and are usually about 1/8 inch (3mm) thick. Pieces are cast upon ordering so if you would like a thinner piece, please note that in the comments.
Pieces will ship in a box with packing material stuffed in the inside of the mask. This should prevent any major deformations. However, you may need to heat up this piece with a hair dryer in order to get it to snap back to its proper shape after shipping.
Mask blanks ship 2-3 weeks after placing your order, as they are made after order is placed. If you need a piece more quickly please message me at micah@micahebbe.com and I may be able to get it out sooner!
While I try to answer all my messages I am unable to offer step-by-step instructions on how to finish this piece.
If you are looking for more information on how to finish latex masks, please check out the Stan Winston school tutorials!
Please read entire listing before purchasing.
This is an unfinished raw latex pull of my zombie mask design. It will require some know-how to finish.
All edges are left intact from the mold. Eyeholes are uncut. Large airbubbles are patched, but the piece may have small surface imperfections that can be covered with paint or PAX (see close-up image for an example of air bubbles).
Latex pieces are cast using Reynolds Latex and are usually about 1/8 inch (3mm) thick. Pieces are cast upon ordering so if you would like a thinner piece, please note that in the comments.
Pieces will ship in a box with packing material stuffed in the inside of the mask. This should prevent any major deformations. However, you may need to heat up this piece with a hair dryer in order to get it to snap back to its proper shape after shipping.
Mask blanks ship 2-3 weeks after placing your order, as they are made after order is placed. If you need a piece more quickly please message me at micah@micahebbe.com and I may be able to get it out sooner!
While I try to answer all my messages I am unable to offer step-by-step instructions on how to finish this piece.
If you are looking for more information on how to finish latex masks, please check out the Stan Winston school tutorials!